Sharp IQ-8000 Manual de instalación descargar pdf (Pagina 66)

7.4 Setting MODEM or Direct Connect Configurations

PCSC supports the US Robotics 33.6/56K Sportster model for MODEM communication. It is

recommended that the MODEM be powered up via an U.P.S. (Uninterruptible Power Supply).

NOTE: The US Robotics 33.6/56K Sportster has not been evaluated by UL,

and is not suitable for UL installations.

To set up the IQ-400 for MODEM communication, configure the Dipswitch settings at SW1, as

follows:

Example: MODEM connection (IQ-400, panel address is #1)

NOTE AT SW1, switch #8 must remain in the ON position (left) for MODEM

communication.

To set up the IQ-400 for direct connect communication (default), configure the Dipswitch settings

at SW1, as follows:

Example: Direct connection (IQ-400, Panel address is #1)

NOTE At SW1, switch #8 must remain in the OFF position (right) for Direct

Connect communication.

To communicate from an IQ-400 to the MODEM, two cables must be fabricated: one from the

MODEM to the IQ-400 and another for the PC host to the MODEM. See the diagrams under

Cable Requirements.

NOTE The ON/OFF designation is in reference to the labels printed on the

IQ-400 PCB. Not the switch itself!

Page liii of 110 IQ-400 Installation Manual 33-10057-001-C

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 124 125

Sin comentarios

Sharp IQ-8000 Manual de instalación Pagina 66