Sharp IQ-8000 Manual de instalación Pagina 62

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 125
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 61
7.0 Communicating with the IQ-400
The IQ-400 can communicate over a dialup MODEM, an RS232 or an RS485 serial direct
connection or LAN. In a multi-drop IQ-400 configuration, the IQ-400 MUST communicate via
RS-485 protocol.
7.1 Reset the IQ-400 Panel
You may elect to install the supervisory resistors at this time or optionally wait until after on-line
communication has been established to the LiNC-NET Host PC. Set dipswitches 1-8 (located at
SW1) to OFF position as it is etched on the IQ-400 PCB. Hit the reset switch at S1. This will
calibrate and reset data to default, all 14 of the supervised inputs on the IQ-400 PCB and the
supervised Door Senses on the 4/8-Door Cluster PCBs.
Page xlix of 110 IQ-400 Installation Manual 33-10057-001-C
Vista de pagina 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 124 125

Comentarios a estos manuales

Sin comentarios