Sharp IQ-8000 Manual de instalación descargar pdf (Pagina 23)

3.1.5 Resetting the IQ-400 to Default Values

In the event that the 3-volt watch battery is removed or loses its electrical charge, the

IQ-400 must be reset. Follow the procedures below to restore the controller to the default

values.

1. With power on, move all switches at dipswitch SW1 to the right, OFF (as printed on the circuit

board).

2. Press the Reset button at S1.

3. The 10 LEDs (D39 – D48) will flash in waterfall effect and then stop. The 7-segment LEDs

(D49 and D50) will show 8.8. and then show a Hexadecimal number dependant on what

version of firmware you have in the controller. The input LEDs will start a cascade and then

flash when the reset process is complete, all 10 segments of the LED Array (D1) will turn

OFF, and the seven segment LEDs will show a single line segment flashing in a circular

pattern clockwise.

4. Refer to Section 7.3 [Addressing Individual IQ-400s through the Dipswitch] and begin

addressing the IQ-400 by DIP switching the panel number (1-111).

5. Set the communication protocol by following the instructions on section 7.4 [Setting MODEM

or Direct Connect Configurations].

6. The system is now set to the default values. Refer to Quick Setup Steps for page references.

Page x of 110 IQ-400 Installation Manual 33-10057-001-C

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 124 125

Sin comentarios

Sharp IQ-8000 Manual de instalación Pagina 23