Sharp IQ-8000 Manual de instalación descargar pdf (Pagina 15)

The LiNC-NET Network Controller communicates on a multi-point RS485 communication cable

(RS-232, MODEM and LAN communication are also available). You must address each IQ-400

with a unique ID number (1-111) in order to communicate to each IQ-400 panel. Numbering the

IQ-400s should be in ascending order, but it is not required for operation.

NOTE To be installed in accordance with NEC 70. Also should be installed in

accordance with the Standard for Installation and Classification of

Burglar and Holdup Alarm Systems, UL 681.Installation must meet all

local, state, and federal regulations and codes for electrical installation. If

these codes conflict with the installation methods described in this

manual, please call your service representative.

UL LISTINGS The IQ-400 control unit is UL listed to the standard for Access

Control System Units, UL 294. The following card readers have been

found compatible by UL with the IQ-400: PCSC Models BR-370 and

BR-470; HID Models PR-234 and PRK-234; and AWID PR-732, 733.

NOTE: The US Robotics 33.6/56K Sportster modem (Section 7.4) and the

LANtronix MSS1-T RS-232 Serial Terminal Server (Section 8.6) have not

been evaluated by UL, and is not suitable for UL installations.

Page ii of 110 IQ-400 Installation Manual 33-10057-001-C

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 124 125

Sin comentarios

Sharp IQ-8000 Manual de instalación Pagina 15