Sharp IQ-8000 Manual de instalación descargar pdf (Pagina 18)

•

Jumper W2 is located in the LOWER RIGHT side of the board, to the left of Plug P16

and is set for 4 or 5 wire readers. (Must be set consistently with Data format set on

W1, W3 and W4).

5. Across Pins #1 and #2 = 5-wire Wiegand Data (Data0,

Data1) format

6. Across Pins #2 and #3 = 4-wire PCSC Data format

•

Jumper W1 is located in the LOWER RIGHT (CENTER) side of the board, to the left

of W2 and is set for 4 or 5 wire readers. (Must be set consistently with Data format set

on W2, W3 and W4).

7. Across Pins #1 and #2 = 5-wire Wiegand Data (Data0,

Data1) format

8. Across Pins #2 and #3 = 4-wire PCSC Data format

•

Jumper W4 is located in the LOWER LEFT (CENTER) side of the board, to the left of

W1 and is set for 4 or 5 wire readers.

NOTE: It must be set consistently with data format set on W1, W2 and W3.

9. Across Pins #1 and #2 = 5-wire Wiegand Data (Data0,

Data1) format

10. Across Pins #2 and #3 = 4-wire PCSC Data format

•

Jumper W3 is located in the LOWER LEFT side of the board to the left of W4 and is

set for 4 or 5 wire readers.

NOTE: It must be set consistently with data format set on W1, W2 and W4.

11. Across Pins #1 and #2 = 5-wire Wiegand Data (Data0,

Data1) format

12. Across Pins #2 and #3 = 4-wire PCSC Data format

Page v of 110 IQ-400 Installation Manual 33-10057-001-C

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 124 125

Sin comentarios

Sharp IQ-8000 Manual de instalación Pagina 18