Sharp JW-50FL Manual de usuario Pagina 37

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 201
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 36
1 - 30
Bar Code Reader Interface
12
It is possible to receive the signal from a bar code reader by connecting a bar code reader to ZM-
**
via
the modular jack (MJ1/MJ2) of ZM-
**
series.
To connect a bar code reader to ZM-
**
via MJ1/MJ2, use the cable use the Bar Code Connecting Cable
ZM-80BC which is the optional equipment made only by demand.
Length : 2m
Accessory : Modular Plug
Notes on Connection
In case of using the bar code reader which uses the CTS and RTS control, the bar code reader may not
work normally without jumping RTS and CTS.
The output power supply (+5V) is max. 150mA. (Refer to the preview page.)
When the bar code reader connected to ZM-41/70 Series is used, connect it to ZM-
**
by the following
cable.
Pin No.
1
2
3
4
5
6
7
8
9
Signal
CTS
RXD
TXD
RTS
SG
+5V
Red : 0V
Orange : RXD
Yellow : TXD
Brown : +5V
12345678
* Jump pins, 1(CTS) and 4(RTS).
D-sub 9pin(凹)
Signal
RTS
TXD
RXD
CTS
SG
+5V
Barcode Reader
*
Red : 0V
Orange : RXD
Yellow : TXD
Brown : +5V
12345678
1 Bar Code Reader Interface
Vista de pagina 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 200 201

Comentarios a estos manuales

Sin comentarios