Sharp MX 2700N - Color Laser - All-in-One Manual de instrucciones descargar pdf (Pagina 32)

2 SafeCom Controller

D60700-07

2.7.4 Printer web page

The Printer web page can be opened from the Advanced Configuration web

page (2.7.2) by clicking on Printer.

Select Network – Port 9100 if the SafeCom Controller connects to the printer

via the network. On the obsolete SafeCom Controller 3 Port and 1 Port select

Parallel Port if the printer is connected to the SafeCom Controller’s PAR1 port.

Printer IP Address must be correct if the SafeCom Controller is to control

copying on any attached MFP. For fixed IP addresses, use the printer's IP

address. For DCHP IP addresses, use the printer’s hostname.

Use auto-configuration should normally be YES to allow the SafeCom

Controller to automatically determine the Printer Manufacturer and Print

Model. Both of these are used to ensure correct operation of the SafeCom MFP

Cable. SafeCom Go should be YES if Printer Manufacturer is Xerox and the

MFP is EIP-enabled.

Copy Enabled should be YES if a SafeCom MFP Cable is connected to control

copying. The process of enabling Copy Control is MFP dependent and covered in

more detail in 2.6.

Copy Idle Timeout. When the SafeCom controller automatically logs-out the

user after the MFP is idle for a length of time. If Idle timeout is set to 0 there

is no timeout.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 53 54

Sin comentarios

Sharp MX 2700N - Color Laser - All-in-One Manual de instrucciones Pagina 32