Sharp R-9360 Información técnica descargar pdf (Pagina 94)

Preparing Cartridges

A-6 Tenth Edition 9871

The two kinds of cartridge labels are:

• Customer label

• Volume serial number (VOLSER) label

Note: The VOLSER label has optical character recognition (OCR) and both

bar code components.

Place the labels on the recessed areas provided on each cartridge:

1. Make sure that the cartridge has been at room temperature for at least 24

hours.

2. Clean the surface where the labels will be placed using a cleaning solution

made for this purpose. See “Cleaning the Cartridge Exterior” on page A-15.

3. Peel the backing from the labels.

4. Position the labels as shown in Figure A-7 on page A-7 through Figure A-12

on page A-9.

5. Center the labels with the adhesive side toward the cartridge surface and

press into place.

The label must be within the indented area of the cartridge so that the edges of

the label are parallel to the edges of the cartridge. The label should be close to

the inside edge of the indented area but must never overlap the edge of this

area.

Notes:

1. Make sure the labels are not placed elsewhere on the cartridge

surface.

2. Make sure the edges of the labels do not curl up; curling causes the

cartridge to stick in the transport loader.

3. Use labels that do not leave a residue when removed.

4. Make sure the label contains a VOLSER.

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 119 120

Sin comentarios

Sharp R-9360 Información técnica Pagina 94