Sharp R-9360 Información técnica descargar pdf (Pagina 100)

Preparing Cartridges

A-12 Tenth Edition 9871

Setting the SD-3 Write Protect Switch

You can set the write protect switch so that the cartridge is read-only (nothing

can be written on the tape). Slide the switch to the right so that the pencil icon

is split as shown in Figure A-16. In this position, the drive can only read data

from the tape and can not write data.

You can set the write protect switch so that the SD-3 cartridge is write enabled.

Slide the switch to the left so that the pencil icon is joined as shown in

Figure A-16. In this position, the drive can write as well as read data. This

setting is recommended when entering cartridges into the LSM.

Note: Some software has a feature called virtual thumbwheel, allowing read-

only access to a cartridge that is not physically write protected.

Figure A-16. SD-3 Cartridge Write Protect Switch

0867

LABELS

LEADER

BLOCK

DETENT

SPRINGS

WRITE ENABLE POSITION

WRITE PROTECT POSITION

1 2 ... 95 96 97 98 99 100 101 102 103 104 105 ... 119 120

Sin comentarios

Sharp R-9360 Información técnica Pagina 100