Sharp R-323T Especificaciones descargar pdf (Pagina 12)

VISUAL OBSERVATIONS

Check thermocouple position in flame. Refer to

Figure 8. The Thermocouple should be seated

securely in its bracket with the sensing end ex-

tended over the flame, as shown. Lack of proper

Thermocouple position can cause flame blowout

symptoms or failure to hold the flame when try-

ing to ignite the burner.

Check thermocouple connection to the Inter-

rupter and the Interrupter connection to the Gas

control insuring connections are tight. The same

flame failures as stated above can result from

loose connections.

DO NOT OVER-TIGHTEN THE CONNECTIONS

ON EITHER SIDE OF THE INTERRUPTER. THE

CORRECT PROCEDURE FOR BOTH CONNEC-

TIONS IS TO TURN THE CONNECTOR UNTIL IT

IS FINGER TIGHT; THEN TIGHTEN IT A QUAR-

TER TURN MORE.

Check the orange wires from the Interrupter

switch to the Selector switch to insure good con-

nections from the Interrupter terminals to G3 & W3

on the Selector switch. Refer to Figures 9 and 10.

Figure 8 - Burner Assembly

CAUTION

Figure 10 - Orange Wire Connections

Figure 9 - View of Interrupter Switch

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Sin comentarios

Sharp R-323T Especificaciones Pagina 12