Sharp JW-20CM Manual de usuario descargar pdf (Pagina 168)

9·70

Start

Turn “OFF” the PC power

Remove the cables from the JW-20CM

Remove the JW-20CM from the rack panel

Set the switches of the new JW-20CM

Install the new JW-20CM

Connect the cables to the new JW-20CM

Turn “ON” the PC power

Load the parameters.

End

(5) Module replacement procedure

When you want to change the JW-20CM due to an operation fault (lighting FT lamp) etc., follow the

procedures below.

Make sure to store the set parameters onto a floppy diskette using a support tools.

(See the next page)

Operation procedure

Loosen one retention screw and

take out from the rack panel.

(See chapter 9·19)

Load the parameters stored in the

floppy diskette into the new JW-20CM

and write in the EEPROM, then start

operation. For details, see chapter 11.

1 2 ... 163 164 165 166 167 168 169 170 171 172 173 ... 229 230

Sin comentarios

Sharp JW-20CM Manual de usuario Pagina 168