Sharp AH-X10BE Manual de usuario descargar pdf (Pagina 7)

14.17: Position and Secure Center Roof Cap (117) along Truss.

14.18: Connect centers of Roof Caps (117).

SS (2)

CAUTION

Only hand tighten screws in Roof Caps. Do not overtighten.

Overtightening may damage Roof Caps and void

warranty.

Only use a hand

screwdriver on this

step

SS (4)

14.19: Position and Secure Rear Roof Cap (116) along Rear Gable.

14.20: Connect Rear & Center Roof Caps.

SS (4)

SS (2)

Hardware Bags:

1001632

Hardware Bags:

1001632

Hardware Bags:

1001632

Hardware Bags:

1001632

Screwdriver

O1.3: Place the 2” x 4” x 90 1/2”

boards on the inside of the frame. Nail

each board in place with the 16d nails.

15.25”

16”

O1.2: To ensure you have

studs in the correct locations to

nail plywood in the next step, start

measuring here & measure from center

to center.

O1.4: Square up the frame by measuring

from corner to corner. Measurement A

should equal Measurement B.

O1.5: Line up a large sheet of outdoor

rated plywood (48” x 93.5”) with the end

of the frame (same end you measured

from). Nail plywood in place.

O1.6: Place next large sheet. Cut last sheet of plywood to ﬁ t remaining

space (22” x 93 1/2”) on frame. Nail plywood in place.

O1.7: Drill 3 evenly spaced 1/2” drain holes in plywood between each

2” x 4” joist.

O1.8: Place platform in the desired location. If platform does not rest level on the ground, build up low points with loose

dirt until platform is stable.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Comentarios a estos manuales

Sin comentarios

Sharp AH-X10BE Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Sharp AH-X10BE