Sharp AH-X10BE Manual de usuario descargar pdf (Pagina 10)

Place Screw (TC) in this hole to

keep window from sliding up

too far. Insert until ﬂ ush with

the window.

3.1: Remove plastic sheeting from Window (AA) and slide

Window into slot on the Window Wall Panel (125). Attach a

Window Latch (HQ) above each corner of the Window as

shown. When tightening screws (SS), be sure that Window

Latches will slide freely. Do not overtighten. Insert screw (TC)

into the hole in the window. Set panel aside.

Window Assembly

Hardware Bags: Screwdriver

SS (4)

HQ (2)

TC (1)

1033420, 1001632

1033168

Insert window with bent edge at top

and pointing away from the wall.

4.1: Fold Left Front Corner Panel (105). Fit tabs of panel into the front left corner (while facing shed) of your ﬂ oor.

Place a Wood Block (BC) under ﬂ oor panel, directly under ﬁ rst tab, then pull down on Corner Panel until tab snaps

into place. Move block under the next tab and repeat.

Front Corner Assembly

Place Wood Block (BC) directly under

the tab you are inserting. Snap tabs

into place one at a time.

105

14.11: Install the next Truss and the next two Roof Panels (114).

14.10: Connect centers of Front Roof Cap (115) and Center Roof

Cap (117) with Screws (SS).

Hardware Bags:

1001632

Screwdriver

SS (2)

SS (26)

CAUTION

Only hand tighten screws in Roof Caps. Do not

overtighten. Overtightening may damage Roof

Caps and void warranty.

Only use a hand

screwdriver on

this step

Hardware Bags:

1001632

Screwdriver

14.12: Position the Center Roof Cap (117) and attach to Truss with

Screws (SS).

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comentarios a estos manuales

Sin comentarios

Sharp AH-X10BE Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Acondicionadores de aire del sistema de división Sharp AH-X10BE