Sharp UX-4000M - UX 4000 B/W Laser Printer Guía de usuario Pagina 58

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 194
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 57
EN
Chapter 2: Printing Tasks 47
If the settings are not available from the software, set the custom
paper size from the control panel:
1
From the Printing Menu set
%10(+)74'%7561/2#2'4;'5
.
2
From the Printing Menu, select inches or millimeters as the unit
of measurement.
3
From the Printing Menu, set the X dimension (the front edge of
the paper) as shown in Figure 15. X can be 3 to 8.5 inches (76 to
216 mm).
4
Set the Y dimension (the side edge of the paper) as shown in
Figure 15. Y can be 5 to 14 inches (127 to 356 mm).
5
If custom paper is loaded into Tray 1 and
64#;/1&'%#55'66'
,
then set
64#; 5+<'%7561/
from the Paper Handling Menu in
the printer’s control panel. See “Customizing Tray 1 Operation” on
page 50.
If custom paper is loaded in the optional 500-sheet tray, be sure
the paper size dial is set to Custom (page 29).
6
In the software, select
Custom
as the paper size.
For example, if the custom paper is 8 by 10 inches (203 by 254 mm),
set X=8 inches and Y=10 inches (X=203 millimeters and Y=254
millimeters).
The control panel must be set if the PCL 5e driver is used, or custom
paper is loaded long-edge first (X is longer than Y).
Vista de pagina 57
1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 193 194

Comentarios a estos manuales

Sin comentarios