Sharp DP-750 Manual de usuario descargar pdf (Pagina 36)

DP750 User's Manual

- 32 -

QUIET MODE

Select the printer into quiet mode. The acoustic noise is lower but the printing

speed is reduced by half.

AUTO LF

Select (ON) or cancel (OFF) the automatic advance of the paper by one line

after every carriage return command.

AUTO TEAR OFF

Enable or disable AUTO TEAR OFF function. The feed delay for the tear-off

advance can be set.

This determines the action of the printer while the single sheet paper is front

feeding.

PUSH KEY disables automatic loading allowing loading only by pressing the

LF/FF key. The other options allow automatic feeding after the stated delay

time.

SKEW DETECTION

Enable or disable the skew detection for front feeding, if the paper is more

inclined level set out, the paper automatic retreat. If you use this function value,

please refer to tilt level.

SKEW LEVEL

Sets the Skew sensor sensitivity. 001 is the most critical while 010 is the least.

If a skew error is detected the single sheet will be automatically ejected. Note:

With setting “1” manual feed becomes highly difficult.

PIN SWITCH

Select pins witch mode. The printer auto switches the different pin to print table

Line.

SERIAL I/F

BAUD RATE Set the printer RS-232C interface speed.

PARITY Set the printer RS-232C interface parity error checking type.

DATA BIT Set the printers RS-232C data width either 8 bits or 7 bits.

STOP BIT Set the printers RS-232C transmission stop bits.

PROTOCOL Set the printers RS-232C interface protocol (handshaking).

HEAD PIN

Select broken-pin mode. The default settings is every root printed needle is

live. When the printer Is printing, if user find out broken-pin, please Select

broken-pin mode, then the printer can automatic compensate broken-pin

position.

4.6.5 Online-aptitude Parameter Settings

DP750 supports the function of online-aptitude parameter settings, which can be set in the PC with the

driver installed in.

The concrete setting steps are shown as follows:

1. Make sure that the host and the printer are connected with a cable and both the host and the printer

is turned on, the printer should be online as well.

2. Click “Start” → “Settings” → “Printers”.

3. Right click “Jolimark DP750” in the “Printers”, select “Properties”.

4. Click “Device Property” in the property page.

Table 4-2 Description of options

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 52 53

Comentarios a estos manuales

Sin comentarios

Sharp DP-750 Manual de usuario Pagina 36

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Sharp DP-750