Sharp R-55TSF Instrucciones de operaciones descargar pdf (Pagina 46)

ASSEMBLY

Assembly Section 2-20

CABLE LIFT DRAFT BEAM INSTALLATION

Install ½” O-ring breather into butt port of inboard cylinder. Install fittings in the rod end of the

cylinder according to the diagram in the commons section. These fittings should be positioned

to face the butt end of the cylinder.

Next turn the clevis onto the rod of the cylinder until it is tight against the shoulder and lock

into place with locking bolt on clevis.

The inboard cylinder can now be installed into the main frame mast with the pin, flat-washers

and R-clips as shown below. Use teflon tape on all fitting and hose connections.

DRAFT BEAM MOUNTING

Pull the inboard cylinder piston rod down to the extreme extended position. Slide the draft

beam under the cylinder, and align clevis hole with draft beam hole nearest to the tractor. Install

pin and secure with R-clips.

Using inboard cylinder as a pivot point, slide draft beam under tractor and install draft beam

pin. Align hole in draft beam pin with holes in main frame boss and install cap-screw, lock-

washer and hex nut.

Install the fittings in the butt end of the outboard cylinder, as shown in the commons section.

These should be positioned to face the rod end of the cylinder. Next, install the O-ring breather

in the rod end of the cylinder.

Install the outboard cylinder in the hole in the draft beam as shown above. Install the pin into

the draft beam and cylinder and secure with R-clips.

(ASM-CBL DRFT BEAM-0001)

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 247 248

Sin comentarios

Sharp R-55TSF Instrucciones de operaciones Pagina 46