Sharp AN-LS1 Especificaciones descargar pdf (Pagina 6)

6

Wall Mount

You will find it convenient to mount AN-LS1 on the wall, using two screws, as indicated below.

1 Screw two screws (not included) into the wall 96.5 mm apart.

The heads of the screws should be 5-7 mm in diameter, and the shafts should be 3 mm in diameter.

(It is recommended to use screws of 12 mm or more in length.) Do not screw the screws in all the

way—leave a space of about 4 mm to allow room for sliding AN-LS1’s ears between the wall and

the screws.

5-7 mm

96.5 mm

2 Insert the two screw heads through the large parts of the keyhole shaped apertures,

and then slide AN-LS1 downwards, as indicated.

3 For added stability, simply tighten the two screws.

AN-LS1

POWER

RS-232C(CONTROLLER)

RS-232C(PROJECTOR) INIT. DC IN

TX/RX 10BASE-T LINK

AN-LS1

POWER

RS-232C(CONTROLLER)

RS-232C(PROJECTOR) INIT. DC IN

TX/RX 10BASE-T LINK

• To remove AN-LS1 from the wall mount, simply reverse steps 2 and 3 above.

1 2 3 4 5 6 7 8 9 10 11 ... 53 54

Comentarios a estos manuales

Sin comentarios