Sharp R-95STM Especificaciones descargar pdf (Pagina 35)

ProtoMat 95s/II

Manual

4.2 LPKF

ProtoMat 95s/II

commands

4.3 Command structure

The SMCU (Signal Processor Control Unit) control unit in the machine interprets the HP-GL

commands described below and converts them into defined reactions.

The machine has a resolution of approximately 0.005 mm

This differs from the resolution used by standard HP-GL plotters. The use of master

commands reduces the output.

The syntax:

Symbol Meaning

{...} The contents can be repeated any number of times.

() The command parameters are between these brackets.

[] The content of these brackets is optional and does not have to be included.

The SMCU expects a separator between the command parameters which is neither a

number nor a capital letter. A new command can follow a parameter without a separator. The

last character in a command file which is sent must be a semicolon or a line feed symbol (0A

hex).

Unknown commands are ignored by the control unit, but their parameters can lead to

unwanted Plot A0bsolute or Plot Relative commands.

4.3.1 HP-GL standard commands

AA (x,y,a{,ß}){;}

Arc Absolute

Draws an arc around the absolute coordinate (x,y) starting from the current position

with the arc angle a=[degrees]. It is drawn clockwise where the arc angle a is

negative, but otherwise it is drawn anti-clockwise.

AR (x,y,a{,ß}){;}

Arc Relative

Draws an arc around the relative coordinate (x,y) starting from the current position

with the arc angle a=[degrees]. It is drawn clockwise where the arc angle a is

negative, but otherwise it is drawn anti-clockwise.

CI (r{,ß}){;}

Circle

Draws a complete circle with radius r around the current position. Resolution ß is

ignored as the maximum resolution is always used when drawing.

EA (x,y){;}

Edge Rectangle Absolute

Draws a rectangle defined by two corner points diagonally opposite each other. The

first corner point is determined by the current position and the second by the

absolute coordinate (x,y).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 81 82

Sin comentarios

Sharp R-95STM Especificaciones Pagina 35