Sharp R-426HQ Manual de usuario descargar pdf (Pagina 5)

Unpacking and ExaminingYourOven

Remove:

1. all packing materials from inside the oven cavity;

however, DO NOT REMOVE THE WAVEGUIDE

COVER, which is located on the right cavity wall

s_,o,ydoo,....... Read enclosures and SAVE the

__ Operation Manual.

2. the feature sticker, if there is

one, from the outside of the door.

Check the oven for any damage,

........ _[._,,sa_,_r _ c_/guid_,_ such as misaligned or bent door,

damaged door seals and sealing

surfaces, broken or loose door hinges and latches and

dents inside the cavity or on the door. if there is any

damage, do not operate the oven and contact your

dealer or SHARP AUTHORIZED SERVICER.

Cheesing a Leeatienfer YeurOven

You will use the oven frequently so plan its location for

ease of use. It's wise, if possible, to have counter space

on at least one side of the oven. Allow at least 2 inches

on the sides, top and at the rear of the oven for air

circulation. Do not place or install the oven in any area

where heat and steam are generated; for example,

next to or above a conventional gas or electric range

or above a conventional wall oven. Heat and steam

may damage the electronics or the mechanical parts of

the oven.

Built-in Kit

Your oven can be built into a cabinet or wall--net

near or above a heat source--using Sharp's white

Built-in Kit RK=46W24 for the R-426HW, black

RK-46K24 for the R-426HK, R-426HQ and stainless

steel RK=46S24 for the R-426HS. If your dealer does

not stock the kit, it can be ordered directly from the

Sharp Accessories and Supplies Center. Have your

credit card number available and cal! tol!-free:

!=800=642=2122 for ordering the kit to be sent to

your address.

The kit includes ducts, finish trim strips and easy-to=

follow instructions for installation as well as the

location of the power supply.

This appliance must be grounded. This oven is equipped with a cord having a grounding wire with a grounding plug.

it must be plugged into a wail receptacle that is properly installed and grounded in accordance with the National

Electrical Code and Ioca! codes and ordinances. In the event of an electrical short circuit, grounding reduces risk of

electric shock by providing an escape wire for the electric current.

WARNING = improper use of the grounding plug can result in a risk of electric shock.

Electrical Requirements

The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more Permanent and Correct _nstaiiation

protected electrical supply. It is recommended that a separate circuit serving

only this appliance be provided.

The oven is equipped with a 3=prong grounding plug. It must be plugged into a

wall receptacle that is properly installed and grounded. Should you only have a

2-prong outlet, have a qualified electrician install a correct wall receptacle.

A 3=prong adapter may be purchased and used temporarily if local codes allow.

Fo!low package directions.

A short power-supply cord is provided to reduce risk of becoming entangled in

or tripping over a longer cord.

Extension Cord

if it is necessary to use an extension cord, use only a 3-wire extension cord that

has a 3-blade grounding plug and a 3-slot receptacle that will accept the plug on Temporary Use

the microwave ovem The marked rating of the extension cord should be AC 115-

Ground

120 volt, 15 amp. or more. Grounding Receptacle Box

Be careful not to drape the cord over the countertop or table where it can be Adapter__S_

pulled on by children or tripped over accidentally. "*¢-I_?_--_

Notes:

1. If you have any questions about the grounding or electrical instructions, Scr

consult a qualified electrician or service person.

2. Neither Sharp nor the dealer can accept any liability for damage to the oven TGarobundingfOrScrew _

or personal injury resulting from failure to observe the correct electrical

connection procedures.

Radio or TV Bnterference

Should there be any interference caused by the microwave oven to your radio or TV, check that the microwave oven

is on a different electrica! circuit, re!ocate the radio or TV as far away from the oven as feasible or check position and

signal of receiving antenna.

3iprong P:ug

Grounding Pin

3-Prong Receptac',e

Ground /

Recept ac',e Box

1.426HK/W/S #350MRK1 3 _ 10/17/03, 10:59 AM

1 2 3 4 5 6 7 8 9 10 ... 23 24

Comentarios a estos manuales

Sin comentarios

Sharp R-426HQ Manual de usuario Pagina 5

Comentarios a estos manuales

Relacionado con productos y manuales para Microondas Sharp R-426HQ