Sharp R-310J Manual del operador descargar pdf (Pagina 11)

Page 11

CARRIAGE ADJUSTMENT AND PRODUCT PLACEMENT

SET CARRIAGE AS FOLLOWS

1. The product centerline should be slightly behind drive roller centerline

when carriage is up, as shown by “Y” dim. in Fig. 5;

2. When product (A) is against drive roller, you should have a minimum 3/16”

distance (dim.Z, Fig. 5) between product and peeler plate for product to sit

well down between carriage idler rollers, (B, Fig.5)

Use a 9/64 Allen wrench to loosen 4 cap screws (C) and relocate carriage

blocks. Also keeps in mind that moving the lower carriage roller assembly

forward or back in the actuator arm will affect values of “Y and Z”. Refer to Fig. 6

on page 12 for this adjustment. You will have achieved close to equal spacing if

roller centers visually form a triangle as shown by dotted lines in Fig. 5.

After verifying that a product works well at a given setting, it would be a good

idea to mark the rods where carriage blocks are set.

Fig 5

Carriage Blocks

Drive

Roller

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 45 46

Sin comentarios

Sharp R-310J Manual del operador Pagina 11