Sharp AR-C360P Especificaciones descargar pdf (Pagina 17)

1-17 Quick path to installation

Sharp AR-C360P EFI Configuration Guide - 17

Quick path to installation

The diagrams on the following pages show typical systems you

can use to print and run Fiery software from remote workstations.

Find the page with your preferred platform and network type, and

then look up the setup procedures referenced in the “Key to

setup” in the upper-left corner of each diagram.

The diagrams describe devices that use the supported networking

protocols. They are logical diagrams and are not intended to

describe the physical arrangement (topology) of devices on the

network. A variety of physical arrangements is possible with each

logical arrangement. For example, twisted pair Ethernet networks

commonly use a star configuration around a hub, rather than a

bus arrangement. The design of physical networks is beyond the

scope of this manual.

If your network uses more than one protocol or more than one

type of workstation, combine the setups listed for each

component of your system. Multiple protocols (shown in the

diagrams as parallel lines) can run on the same cable. A solid

connection from the Fiery with an arrow indicates that other

supported network types can be operational at the same time.

The protocols used in these diagrams are indicated as follows:

AppleTalk

IPX (Novell)

Other

TCP/IP

(lpd, nbt, or

http)

Parallel

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 180 181

Sin comentarios

Sharp AR-C360P Especificaciones Pagina 17