Sharp XE-A213 Manual de instrucciones

Busca en linea o descarga Manual de instrucciones para Cajas registradoras Sharp XE-A213. Sharp XE-A213 Instruction manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 19
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
XE-A213 Frequently Asked Questions Page 1 of 19
XEA213Frequently asked questions.
How do I prepare my XEA213 for set-up?
Take the XEA213 out of its box, remove the packing materials. Place the XEA213 on
a flat stable surface, close to a power outlet. Also insure it will not be exposed to
direct sunlight, and is away from water (taps, sinks, etc).
How do I clear the XEA213 to ready it for programming?
It is very important that you “initialise” the XEA213 correctly once you have
removed it from the box, and are ready to start programming. If you do not
“initialise” the XEA213, it might not work correctly.
1. Insert the MA key into the mode switch and turn it to the REG position.
2. Insert the plug of the power cord into a power outlet.
This must be done without the batteries installed. If you have installed
batteries; be sure to remove them before you start this procedure.
The display will show: *** MRS. *** for about six seconds. The buzzer will
then sound three times. If the buzzer does not sound three times, please try
again.
The cash register has now been “initialised”. If there were any data from a previous
programming attempt it would have been cleared. The display should now show:
NO BATTERY.
Vista de pagina 0
1 2 3 4 5 6 ... 18 19

Indice de contenidos

Pagina 1

XE-A213 Frequently Asked Questions Page 1 of 19 XEA213Frequently asked questions. How do I prepare my XEA213 for set-up? Take the XEA213 out of i

Pagina 2

XE-A213 Frequently Asked Questions Page 10 of 19 10. Use the numeric key pad to enter the department that the PLU should be grouped under. This mu

Pagina 3

XE-A213 Frequently Asked Questions Page 11 of 19 How do I get my business name and ABN to print on the receipt? 1. Set the mode key to the PGM po

Pagina 4

XE-A213 Frequently Asked Questions Page 12 of 19 8. Enter the fourth line do the following: ST 4 _●_ 4 __ use the keyboard to type

Pagina 5 - How do I set a 10% GST rate?

XE-A213 Frequently Asked Questions Page 13 of 19 How do I allow for printing copy receipts? 1. Set the mode key to the PGM position 2. To all

Pagina 6

XE-A213 Frequently Asked Questions Page 14 of 19 How do I make the decimal point key work; so I can sell other than full units. For: example 2.5 m

Pagina 7

XE-A213 Frequently Asked Questions Page 15 of 19 How shall I know when it is time to replace the batteries? The XEA213 will display a low battery

Pagina 8

XE-A213 Frequently Asked Questions Page 16 of 19 How do I make a sale? 1. Turn the mode key to REG 2. Sign on a clerk. For example to sign on

Pagina 9

XE-A213 Frequently Asked Questions Page 17 of 19 The XEA213 displays “OVER LIMIT” when I try to finalise a sale to cash. How do I fix this? 1. F

Pagina 10 - to confirm the PLU’s type

XE-A213 Frequently Asked Questions Page 18 of 19 How do I produce sales reports? There are two type types of reports: X or e(X)amine reports

Pagina 11

XE-A213 Frequently Asked Questions Page 19 of 19 To produce a daily Z report, do the following: 3. Turn the mode key to X1/Z1 position 4. Pres

Pagina 12

XE-A213 Frequently Asked Questions Page 2 of 19 How to install the batteries, and why should I do so? The XEA213 uses 3 x AA size batteries to hol

Pagina 13

XE-A213 Frequently Asked Questions Page 3 of 19 What sort of paper roll do I use, and how do I install it? The XEA213 uses a thermally sensitised

Pagina 14

XE-A213 Frequently Asked Questions Page 4 of 19 4. Feed the end of the paper along with the paper position guides as shown in the diagram below.

Pagina 15

XE-A213 Frequently Asked Questions Page 5 of 19 How do I set the time and date? 1. Set the mode key to the PGM position. 2. Enter the time as

Pagina 16 - How do I make a sale?

XE-A213 Frequently Asked Questions Page 6 of 19 How do I set a Department as taxable or not taxable? 1. Set the mode key to the PGM position 2.

Pagina 17 - ST

XE-A213 Frequently Asked Questions Page 7 of 19 How do I set the letters GST to print on the receipt? 1. Set the mode key to the PGM position 2

Pagina 18

XE-A213 Frequently Asked Questions Page 8 of 19 How do I give a department a descriptive name? 1. Set the mode key to the PGM position 2. Press

Pagina 19

XE-A213 Frequently Asked Questions Page 9 of 19 How do I program the PLUs? (Price Look Ups) The XEA213 is set at Master Reset (Factory Default) to

Comentarios a estos manuales

Sin comentarios