
Setting up the Computer
To use the touch panel, the touch panel driver must be installed and the touch panel must be connected to your computer.
Installing the touch panel driver
The touch panel driver is a program that enables you to use the touch panel to operate the computer that is connected to the
touch panel.
Caution
• To install, an administrator name (user name) and password are required.
• If an older version of the touch panel driver is installed, remove (uninstall) the old version before installing the touch panel
driver. (See page 9.)
• If you are using a USB hub, use a self-powered hub (a hub capable of supplying a 500 mA current). The touch panel will not
operate correctly if a bus-powered USB hub is used.
• Do not touch the touch panel when connecting the USB cable.
If you touch the touch panel, it will lead to a malfunction. In this case, disconnect and then reconnect the USB cable.
1. Start your computer.
2. Exit all applications that are running.
3. Connect the USB cable for the touch panel to the computer.
USB cable (Supplied)
To the USB terminal
of the computer
USB port
USB port
PN-L802B
4. Run the setup program.
(1) Double-click the “TouchPanelDriver” folder.
(2) Double-click “Sharp TouchPanal.mpkg”.
5. Click “Continue”.
Follow the on-screen instructions to install the driver.
• If a screen prompting you to enter the name and password appears, enter the name and password of the administrator
and click “Install Software” (or “OK”).
• If the “When this software nishes installing, you must restart your computer. Are you sure you want to install the software
now?” screen appears, click “Continue Installation”.
6. Whentheinstallationnishedscreenappears,click“Restart”.
This completes the installation of the touch panel driver.
Each time the computer is started, the touch panel driver will start automatically to enable the touch panel to be used.
The rst time you use the touch panel, perform calibration (position adjustment). (See page 6.)
Comentarios a estos manuales