Sharp XG-E3500U Guía de instalación descargar pdf (Pagina 3)

Smart Panel Projector Driver Application Note

Sharp XG-E3500U

[email protected]

II. CONTROL WIRING

PROJECTOR CONTROL

RS232 IR/SERIAL

GND

CTS

RTS

+12V

GND

IR/SER

SENSE

Female DB9

RS-232 to

PC CONTROL

1/8" Mini

Female

1/8" Male Mini to 1/8" Male Mini

(not included)

Wired Remote to

WIRED REMOTE

Optional Intermediate Female DB9 to Male DB9

(not included)

54321

987

54321

This section specifies how RS-232 and Wired Remote

should be wired to the Sharp projector.

RS-232 should be connected to the Sharp control port

labeled

PC Control

. Connection should be as follows:

1. Wire the Panel to a female DB9 as shown.

2. Connect this female DB9 to the projector port labeled

PC Control

3. Optionally, an intermediate cable (female DB9 to male

DB9) may be used to facilitate service to the projector

or Panel.

The Wired Remote should be connected to the Sharp

port labeled

Wired Remote

. Connection should be as

follows:

1. Wire the Panel to a female 1/8" Mini as shown; wire

IR/SER

tip

and

GND

ring.

Direct wiring to male

1/8” is not recommended as it makes removal of the

Panel for service more difficult.

2. Attach to the projector port labeled

Wired Remote

using

a male 1/8” mini to male 1/8” mini (not included).

3. Alternately, replace the male to male cable with the

included the IR Emitter and attach it to one of the IR

windows on the projector. The emitter glows red when

IR is emitted so wiring can be verified.

1 2 3 4 5

Comentarios a estos manuales

Sin comentarios

Sharp XG-E3500U Guía de instalación Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores Sharp XG-E3500U