Sharp ER-A440 Manual de usuario descargar pdf (Pagina 37)

CHAPTER 3. OP X/Z, X1/Z1,X2/Z2

MODE

The following categories of reports can be printed by the ECR.

OP X/Z reports: These reports are taken by operators in order to

report their own sales data.

XI/Z1 reports: These reports are taken by the supervisor or man-

ager in order to check and report daily sales totals

at that point.

X2/Z2 reports: These reports are taken by the owner or manager

in order to check and report periodic (weekly or

monthly) tatals.

MGR/Flash-read: These reports are taken by the owner or manager

in order to check and display daily sales totals at

that point.

To print reports, use the following key entry sequence

JOB#

@/FOR

CA/AT

Reading

Resetting

Range is required

MODE 1

OP X/Z X1/Z1 X2/Z2 F-read

JOB#

DATA FOR

READING

NOTE

REPORT NAME X Z X1 Z1 X2 Z2 X1

GENERAL

00 —

DEPT/GROUP

10 —

IND. GROUP

12 GROUP No.

GROUP TOTAL

13 —

PLU BY RANGE

20 PLU CODE 2

PLU BY DEPT

21 DPT CODE

PLU ZERO SALES

27 ALL

PLU PRICE CATEGORY

29 PRICE 2

TRANSACTION

30 —

CID

31 — ALL CASHIER

ALL CASHIER

50 —

IND. CASHIER

51 —

HOURLY (ALL)

60 —

HOURLY (RANGE)

60 TIME 2

DAILY NET

70 —

STACKED REP

90 —

1 X1: Daily X report Z1: Daily Z report

X2: Periodic X report Z2: Periodic Z report

Stop of printing reports:

The printing of all reports can be stopped by the following operation.

Set the mode switch to "MRG" to cancel.

Note) When the printing is stopped, the consecutive number or Z

counter don’t return to the original value.

When Z reports, Memory is not reset.

1 X1: Daily X report

X2: Periodic X report

Z1: Daily Z report

Z2: Periodic Z report

2 The time interval range, PLU code range can be specified by

entering the start and end numbers according to the following

procedure. When specifying a single time interval, PLU code,

the start number has only to be entered.

3 When 2 is entered in the third digit of a job code, periodic reports

are printed.

Example: Daily general report; job code 100

Periodic general report; job code 200

*4 Reading display only

→

KEY → CL

(Display amount) (Display initialize)

KEY DEPT = DEPTn key

CID = @/For key

Daily Net = ST key

All

Start No. End No.

@/FOR

XXXXXX XXXXXX

– 36 –

1 2 ... 32 33 34 35 36 37 38

Comentarios a estos manuales

Sin comentarios

Sharp ER-A440 Manual de usuario Pagina 37

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Sharp ER-A440