
-27
Basic Operation
"On-screen Display of INPUT Mode (Example)
Using RGB
Using
Component
INPUT 1 mode
INPUT 3 mode
Using Video
INPUT 2 mode
Using S-Video
➝
➝
➝
INPUT buttons
Switching the INPUT
Mode
Select the appropriate input mode for the con-
nected equipment.
Press , or on the remote
control to select the INPUT mode.
••
••
• When pressing on the projector, input mode
switches in order of
INPUT 1 INPUT 2 INPUT 3
.
Note
• When no signal is received, “NO SIGNAL” will
be displayed. When a signal that the projec-
tor is not preset to receive is received, “NOT
REG.” will be displayed.
• The INPUT mode is not displayed when “OSD
Display” of the “Options” menu is set to
“
” (OFF). (See page 47.)
About the INPUT mode
INPUT 1
(Compo-
nent/RGB)
INPUT 2
(S-Video)
INPUT 3
(Video)
Adjusting the Volume
Press or on the remote con-
trol to adjust the volume.
Note
• Pressing will lower the volume.
Pressing will raise the volume.
• On the projector, the volume can be adjusted
by pressing
or .
"On-screen Display
Volume buttons
Used for projecting images from equip-
ment that sends component signals or
RGB signals connected to the INPUT 1
terminal.
Used for projecting images from
equipment connected to the INPUT 2
terminal.
Used for projecting images from
equipment connected to the INPUT 3
terminal.
XV_Z10E_E_p26_35.p65 03.11.7, 4:15 PM27
Comentarios a estos manuales