Sharp Projector XG-PH80W-N Manual de usuario

MODELXG-PH80W-NXG-PH80X-NDATA PROJECTORSETUP MANUALSetting up the Screen ...2Sc

-10Screen Size and Projection DistanceTele-zoom Lens (AN-PH823EZ: For XG-PH80W-N)F2.1-2.9, f = 32-63 mm16:10 Signal Input (Normal Mode)Picture (Screen

-11Screen Size and Projection DistanceTele-zoom Lens (AN-PH823EZ: For XG-PH80X-N)F2.1-2.9, f = 32-63 mm4:3 Signal Input (Normal Mode)Picture (Screen)

-12Screen Size and Projection DistanceTele-zoom Lens (AN-PH845EZ: For XG-PH80W-N)F2.2-3.1, f = 63.5-117.4 mm16:10 Signal Input (Normal Mode)Picture (S

-13Screen Size and Projection DistanceTele-zoom Lens (AN-PH845EZ: For XG-PH80X-N)F2.2-3.1, f = 63.5-117.4 mm4:3 Signal Input (Normal Mode)Picture (Scr

-14Connecting Pin AssignmentsCOMPUTER/COMPONENT input and COMPUTER/COMPONENT output Terminals: mini D-sub 15 pin female connectorCOMPUTER Input/Output

-15RS-232C Cable recommended connection: D-sub 9 pin female connectorPin No. Signal Pin No. Signal1.2.3.4.5.6.7.8.9.CDRDSDERSGDRRSCSCI1.2.3.4.5.6.7.8.

-16RS-232C Specifi cations and CommandsComputer controlA computer can be used to control the projector by connecting an RS-232C serial control cable (c

-17CommandsExample: When turning on the projector, make the following setting.Computer ProjectorPOWR___1omOKCONTROL CONTENTS COMMAND PARAMETERRETURNPo

-18Setting up the Projector Network EnvironmentThis section describes the basic procedure for using the projector via the network.If the network is al

-191. Connecting the Projector to a ComputerEstablishing a one-to-one connection from the projector to a computer. Using a commercially available LAN

-2Setting up the ScreenFor optimal image quality, position the projector perpendicular to the screen with the projector's feet fl at and level. Do

-202. Setting an IP Address for the ComputerThe following describes how to make settings in Windows Vista®.1 Log on the network using the administrat

-215 Click “Internet Protocol Version 4 (TCP/IPv4)”, and click the “Properties” button.6 Confi rm or change an IP address for the setup computer.1 Con

-223. Setting up a Network Con-nection for the ProjectorSettings for such items as the projector's IP address and subnet mask are compatible with

-233 Confi rm that the values are set properly, and then click the “Apply” button.Close the browser.This completes the network settings.After setting i

-24Controlling the Projector via LANAfter connecting the projector to your network, enter the projector IP address in “Address” on Internet Explorer (

-25Controlling the Projector via LANControlling the Projector and Confi rming the Projector StatusOn this screen, you can perform projector control or

-26Controlling the Projector via LANMaking General Settings for the NetworkEnter “http://XXX.XXX.XXX.X/lanconf.html” (for “XXX.XXX.XXX.X”, enter the I

-27Operating the Projector Using the PJLinkTM ProtocolThe projector conforms with the PJLinkTM standard Class 1.The commands to be used in controlling

-28TroubleshootingCommunication cannot be established with the projectorWhen connecting the projector using serial-connection? Check that the RS-232C

-29? Take the following steps for checking the network settings for the computer.1. Open a command prompt.In the case of Windows® 2000: click “start”

-3Screen Size and Projection DistanceThe projection screen size varies according to the distance from the lens of the projector to the screen. The opt

-30? Check if the “TCP/IP” protocol is operating correctly using the “PING” command. Also, check if an IP address is set.1. Open a command prompt.In

-31DimensionsUnits: inches (mm)961/64 (252.5) 9 61/64 (252.5)1511/64 (385)M4M4M4M4M41957/64 (505)1/8 (3)741/64 (194)121/16 (306)413/64(106.5)37/16(87)

-32DimensionsProjector and Lens Dimensions37/16(87)1511/64(385)61/64(24.2)0(0)[When AN-PH808EX is installed]Unit : inches (mm)37/16(87)1511/64(385)7/6

-4Screen Size and Projection DistanceStandard Zoom Lens (AN-PH818EZ: For XG-PH80W-N)F1.7-1.9, f = 26-34 mm16:10 Signal Input (Normal Mode)Picture (Scr

-5Screen Size and Projection DistanceStandard Zoom Lens (AN-PH818EZ: For XG-PH80X-N)F1.7-1.9, f = 26-34 mm4:3 Signal Input (Normal Mode)Picture (Scree

-6Screen Size and Projection DistanceFixed Wide Lens (AN-PH808EX: For XG-PH80W-N)F2.0, f = 11.4 mm16:10 Signal Input (Normal Mode)Picture (Screen) siz

-7Screen Size and Projection DistanceFixed Wide Lens (AN-PH808EX: For XG-PH80X-N)F2.0, f = 11.4 mm4:3 Signal Input (Normal Mode)Picture (Screen) size

-8Screen Size and Projection DistanceWide-zoom Lens (AN-PH814EZ: For XG-PH80W-N)F1.81-2.29, f = 19.3-25.8 mm16:10 Signal Input (Normal Mode)Picture (S

-9Screen Size and Projection DistanceWide-zoom Lens (AN-PH814EZ: For XG-PH80X-N)F1.81-2.29, f = 19.3-25.8 mm4:3 Signal Input (Normal Mode)Picture (Scr