Sharp PGF-267X Guia de preparacion descargar pdf (Pagina 20)

-20

When Connecting Using

RS-232C

Launch general purpose terminal

emulator.

Input settings for the RS-232C

port of the terminal emulator as

follows.

Baud Rate : 9600 bps*

Data Length : 8 bit

Parity Bit : None

Stop Bit : 1 bit

Flow Control : None

* This is the factory default setting. If the value

of Baud Rate for the projector has been

changed, set Baud Rate here according to

the changed value on the projector.

Input “PJS11234” and press the

“Enter” key.

“OK” is displayed. Input

“PJS25678” and press the “Enter”

key within 10 seconds.

“User Name:” is displayed. Input

the user name and press the

“Enter” key.

If a user name has not yet been set, just

press the “Enter” key.

“Password:” is displayed. Input

the password and press the

“Enter” key.

If a password has not yet been set, just press

the “Enter” key.

•

Setting up the Projector Using RS-232C or Telnet

Connect the projector to a computer using RS-232C or Telnet, and open the SETUP

MENU on the computer to carry out various settings for the projector.

Input “setup” and press the

“Enter” key.

SETUP MENU will be displayed.

▼SETUP MENU

-----------------------------SETUP MENU----------------------------

[1]IP Address [2]Subnet Mask [3]Default Gateway

[4]User Name [5]Password

[6]RS-232C Baud Rate [7]Projector Name [8]DHCP Client

[A]Advanced Setup [D]Disconnect All

[V]View All Setting [S]Save & Quit [Q]Quit Unchanged

setup>

User name and password are not set in the

factory default settings.

If the user name or password is entered

incorrectly three times, SETUP MENU will be

quit.

•

Note

•

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Comentarios a estos manuales

Sin comentarios

Sharp PGF-267X Guia de preparacion Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores de datos Sharp PGF-267X