Sharp XE-A404 Alpha Numeric Thermal Manual de instrucciones descargar pdf (Pagina 4)

XE-A203 and XE-A203B Frequently Asked Questions Page 4 of 17

4. Feed the end of the paper along with the paper position guides as shown in the

diagram below.

5. While holding down the paper, slowly close the print roller arm, and push

down the arm until you hear a click. This means the arm is locked back in

place. The paper will feed automatically

6. Cut off the excess paper using the edge of the inner cover, and replace the

external printer cover. Press the  key to make sure the paper end comes out

of the printer cover and clean paper appears.

If the paper end does not come out. Open the printer cover, and pass the paper

end between the paper cutter and the paper guide of the printer cover, and

replace the cover.

7. If you intend to use the print out as a journal: Insert the paper end into the slot

in the spool. Press the  key to feed more paper if required.

Wind the paper two or three turns around the spool shaft. Set the spool on the

bearing and press the  key to take up any slack in the paper. Replace the

printer cover.

1 2 3 4 5 6 7 8 9 ... 16 17

Sin comentarios

Sharp XE-A404 Alpha Numeric Thermal Manual de instrucciones Pagina 4