Sharp IV-S30J Manual de usuario descargar pdf (Pagina 118)

8-1

Chapter 8: Upgrade Version

IV-S20

Continued on the following page

Set key (SET)

Left key (\)

［IVS20 VERSION UP MENU］

1SYSTEM RECEIVE RUN

2SYSTEM TRANSFERRUN

3BOOT RECEIVE RUN

4BOOT TRANSFER RUN

5ALL INITIALIZE RUN

6POWER ON RESET RUN

Chapter 8: Upgrade Version

To upgrade the IV-S20 system version (improved functions) you simplydownload the new version from a per-

sonal computer.

- The IV-S20 software consists of the "system program," used to set up and execute image processing opera-

tions, and a "boot program" to load the other programs. In some cases, both programs need to be upgraded.

(Refer to our sales department for the latest version of the system software.)

Described below are the procedures for upgrading the program version.

(1) Preparation

Create the folders below for installing the software.

SVXXX.mot VXXX system program

(X is different between versions.)

BVXXX.mot VXXX boot program

(2) Communication settings

Set the protocols for communication with the IV-S20.

- See "Chapter 2: Set Communication."

(3) Setting/operating of IV-S20

1. Turn on the IV-S20.

- Turn on the IV-S20, while pressing and holding down both the left key (\) and the set key (SET) on

the remote key pad at the same time.

- The IV-S20 upgrade version menu (IVS20 VERSION UP MENU) will appear on the monitor.

2. Select the upgrade version menu.

- Move the up and down keys to select the "1 SYSTEM RECEIVE" item and press the set key

(SET).

(The "3 BOOT RECEIVE" item may also be needed to perform the upgrade, depending on the

upgrade conditions.)

1 2 ... 113 114 115 116 117 118 119 120 121 122

Sin comentarios

Sharp IV-S30J Manual de usuario Pagina 118